Qume DataTrak 8 Handbuch PDF herunterladen (Seite 30)

SECTION 3 CONSTRUCTION

Install the 3.3K ohm 8-pin SIP resistor at RP1 (2F).

Be careful to align pin 1.

[ ] Install the 10K ohm trimmers at the following

locations:

[ ] R2 (1A) [ ] R5 (1B)

[ ] Be VERY CAREFUL in reading the resistor color codes

as there are many different values used in this kit.

If needed, use an ohmmeter!

[ ] Install the 1.0K resistors (Brown-Black-Red) at the

following locations:

[ ] R17 (3B) [ ] R19 (2M) [ ] R21 (3M)

[ ] Install the 4.7K resistors (Yellow-Purple-Red) at the

following locations:

[ ] R8 (3A) [ ] R14 (4A) [ ] R22 (3B)

[ ] R23 (4K) [ ] R24 (4L) [ ] R25 (4M)

[ ] R27 (3A) [ ] R39 (2A) [ ] R40 (2A)

[ ] Install four 10K resistors (Brown-Black-Orange) at

the following locations:

[ ] R7 (4J) [ ] R16 (3B) [ ] R18 (3C)

[ ] R36 (U4)

[ ] Install the 7.5K resistors (Purple-Green-Red) the

following locations:

[ ] R9 (0L) [ ] R15 (3A)

[ ] Install the 27K resistors (Red-Purple-Orange) at the

following locations:

[ ] R20 (1A) [ ] R32 (1A)

[ ] R38 (2A)

[ ] Install the 51K resistors (Green-Brown-Orange) at the

following locations:

[ ] R29 (2A) [ ] R34 (U4)

[ ] Install the 30K resistors (Orange-Black-Orange) at

the following locations:

[ ] R10 (0M) [ ] R35 (2A)

[ ] Install the 4.3k resistors (Yellow-Orange-Red) at the

following locations:

[ ] R44 (2A) [ ] R45 (2A)

[ ] Install the 5.1K resistors (Green-Brown-Red) the

following locations:

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 46 47

Keine Kommentare

Qume DataTrak 8 Handbuch Seite 30